# Threads in Canned Cycles

**URL:** <https://sinecorecnc.discourse.group/t/threads-in-canned-cycles/43>\
**Category:** General\
**Created:** [June 2, 2026, 11:37am UTC](https://sinecorecnc.discourse.group/t/threads-in-canned-cycles/43 "2026-06-02T11:37:02Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Guzziwhite](https://avatars.discourse-cdn.com/v4/letter/g/439d5e/32.png) [@Guzziwhite](https://sinecorecnc.discourse.group/u/Guzziwhite)\
**Post date:** [June 2, 2026, 11:37am UTC](https://sinecorecnc.discourse.group/t/threads-in-canned-cycles/43/1 "2026-06-02T11:37:02Z")

</div>

In the canned Cycle for threading, how does the angle setting work ?

---

<div class="post-metadata">

**Author:** ![Aidan](https://avatars.discourse-cdn.com/v4/letter/a/c5a1d2/32.png) [@Aidan](https://sinecorecnc.discourse.group/u/Aidan)\
**Post date:** [June 3, 2026, 1:23pm UTC](https://sinecorecnc.discourse.group/t/threads-in-canned-cycles/43/2 "2026-06-03T13:23:19Z")

</div>

The angle setting (A) controls the taper of the thread. A value of 0° will create a straight thread, while increasing the angle will create a tapered thread. The visualizer shows this with the yellow line running along the bottom of the thread profile. Does that help?